BERTHOLD TECHNOLOGIES LB 480 - Page 9

SENSseries LB 480 Level measurement
BERTHOLD TECHNOLOGIES GmbH & Co. KG
1 – 9
Volume 1-3 Table of Contents
2.28 I/O Setup ..............................................................3 – 354
2.29 Current Output ....................................................3 – 355
2.30 Digital Output......................................................3 – 357
2.31 Level Threshold Settings.....................................3 – 359
2.32 Temp. Threshold Settings ...................................3 – 360
2.33 Digital Input .........................................................3 – 361
2.34 HART Interface.....................................................3 – 362
2.35 Service ..................................................................3 – 363
2.36 PMT.......................................................................3 – 364
2.37 Sensor Temperature ............................................3 – 365
2.38 Test .......................................................................3 – 366
2.39 Test Settings ........................................................3 – 366
2.40 I/O Test Settings ..................................................3 – 369
2.41 Plateau..................................................................3 – 370
2.42 Plateau Measurement .........................................3 – 371
2.43 Plateau View ........................................................3 – 372
2.44 Plateau Information ............................................3 – 372
2.45 Meas Parameter...................................................3 – 373
2.46 Meas Data ............................................................3 – 373
2.47 Meas Settings ......................................................3 – 374
2.48 Meas Readings.....................................................3 – 375
2.49 Access ...................................................................3 – 376
2.50 Identification........................................................3 – 378
2.51 Location ................................................................3 – 378
2.52 Device Information..............................................3 – 379
2.53 Device Revision....................................................3 – 380
2.54 Diagnostic ............................................................3 – 381
2.55 Operating Status .................................................3 – 382
2.56 Ext dev status ......................................................3 – 382
2.57 Device Variables Status.......................................3 – 383
2.58 Config Change Status..........................................3 – 383
2.59 Lock Device Status...............................................3 – 383
2.60 Error Status ..........................................................3 – 384
2.61 Log
........................................................................3 – 387
2.62 Error Log...............................................................3 – 387
2.63 Modification Log .................................................3 – 388
3 Getting Started via the HART
®
Communicator ..............3 – 389
3.1 Steps for Getting Started ........................................3 – 389
4 Quick Guide to Calibration..............................................3 – 391