BK Precision 2194 - Internal Save and Recall

Save and Recall 112
13.2 Internal Save and Recall
Internal save and recall support Setups in Save/Recall. In the following part, the save and recall method and procedures
are introduced.
Save the specied oscilloscope setting in internal memory.
1. Connect the signal to the oscilloscope and obtain stable display.
2. Press Save/Recall key on the front panel to enter the SAVE/RECALL function menu.
3. Press the Save softkey to enter the SAVE function menu.
4. Press the Type softkey and then turn the Universal Knob to select Setups; and then press the knob to conrm.
5. Press the Save To softkey to select Internal to save the current setup of the oscilloscope to the internal memory.
6. Press the Setup softkey button; and then turn the Universal Knob to select the location to save. The internal
memory can save as many as 20 setup les, from No.1No.20.
7. Press the Press To Save softkey to save the current setup to the appointed location. After a few seconds, it will
pop-up the message “Saved to internal le NO.1!”
Load the specied type of le in internal memory.
To recall the setup after having nished the steps above, please do the following steps:
1. Press the Recall softkey enter the RECALLING function menu.
2. Press Type softkey and then turn the Universal Knob to select Setups; and then press the knob to conrm.
3. Press the Recall from softkey to select Internal.
4. Press Setup softkey button; and then turn the Universal Knob to select the location to recall. The internal memory
can recall as many as 20 setup les, from No.1No.20.
5. Press the Press To Recall softkey to recall the current setup form the appointed location. After a few seconds, it
will pop-up the message “Recalled le successfully!"
Note:
If need to delete a setup le in the memory, please save a new setup to the same location to overwrite it.