BK Precision 2194 - LIN Trigger and Serial Decode; Setup for LIN Signals

Serial Trigger and Decode 80
7.5 LIN Trigger and Serial Decode
7.5.1 Setup for LIN Signals
There are two steps of setting the LIN signal, connecting the signal to oscilloscope, specifying the parameters of each
input signal.
1. Touch Decode button to enter the DECODE function menu.
2. Touch Decode and select the desired slot (Decode1 or Decode2).
3. Touch Protocol and then select LIN by turning Universal Knob.
4. Touch Signal to enter the SIGNAL menu as shown in gure 7.22.
Figure 7.28 CAN Signal Menu
5. Touch Source to select the channel that is connected to the LIN signal.
6. Touch Threshold and set the LIN signal’s threshold voltage level by Universal Knob. The threshold voltage level is
for decoding, and it will be regard as the trigger voltage level when set the trigger type to serial.
7. Touch to return previous menu.
8. Touch Congure to enter the BUS CONFIG menu.
9. Touch Baud to set baud rate.
• The baud rate can be set as predened value.
• If the desired baud rate is not listed, select custom option, press the Custom and turn the Universal Knob to
set the desired baud rate.