Reference Waveform 85
8.3 Adjust REF Waveform
1. Refer to the Display REF Waveform section above to display the desired reference waveform.
2. Press the Scale and Position softkey and turn the Universal Knob to adjust the vertical scale and position of the
reference waveform. The vertical scale and position information display at the middle of the screen. The initial values
display at the middle of the screen is the setup that when the reference waveform been saved.
The initial values displayed in the middle of the screen is the setup of the reference saved waveform.
Figure 8.1 Reference Waveform
8.4 Clear Ref Waveform
The oscilloscope does not have the “Clear” option under the REF WAVE function menu.
To clear the appointed reference waveform, you can save a new reference waveform to the same location to cover it.
Or follow the Save/Recall –> Recall –> type and select Security Erase to clear the stored waveform.
To Next Page
Loading...
