Blackmagicdesign ATEM - Page 17

Getting Started
Follow install prompts
Plugins and Applications that are Installed
The ATEM switchers software installs the following components which are used by
ATEMswitchers:
 ATEM Software Control
 Blackmagic ATEM Setup
Blackmagic ATEM Setup is used to configure network settings including
IPaddress, plus lets you update your ATEM switcher’s internal software
On Mac OS, all the files needed to run your ATEM switcher will be installed into a folder called
Blackmagic ATEM Switchers in the Applications folder.
In the Blackmagic ATEM Switchers folder, you will see ATEM Software Control and Blackmagic
ATEM Setup. ATEM Software Control is the software control panel for your switcher, which also
allows loading graphics into the switcher media pool, changing settings, mixing audio,
recording macros and controlling Blackmagic cameras, including Blackmagic Studio Cameras,
Micro Studio Cameras and URSA Broadcast.
17