Performing Transitions using ExternalHardwarePanels
To perform a mix transition on an ATEM broadcast panel:
1 On the preview bus, select the video source that you want on the program output.
2 Press the DIP/MIX button to select the mix transition type. The system control
automatically navigates to the transition menu. To manually navigate to the transition
menu press HOME > TRANS.
3 In the control system, use the knob to adjust the mix rate. The transition rate display in
the transition control block will update dynamically. You can also enter a rate duration
using the number pad followed by the set rate button.
4 Perform the transition as an auto transition or manual transition from the transition
control block.
Mix Transition Parameters
Rate The mix transition rate in seconds : frames.
Dip Transitions
A DIP is similar to a mix in that it is a gradual transition that transitions from one source to
another. However, a dip transition gradually mixes through a third source, the dip source.
For example, the dip transition can be used for a transition that calls for a white flash or a
transition that quickly flashes the sponsor logo. The length of the dip transition and the dip
source can both be customized.
Program output for a dip transition.
To perform a dip transition on the ATEM 1 M/E Advanced Panel:
1 On the preview bus, select the video source that you want on the program output.
2 Press the DIP button to select the dip transition type. The LCD menu will automatically
display the transition settings.
3 In the transition settings, use the corresponding LCD control knob to adjust the dip rate.
You can also enter a rate duration using the number pad. Select a dip source.
4 Perform the transition as an auto transition or manual transition from the transition
control block.
Transition
Mix
1:00
Set Rate
Dip
1:00
Set Rate
FTB
1:00
Set Rate
201
To Next Page
Loading...
