BMW C1 200 - Cylinder Head Cover Removal and Installation

11.34
When installing:
L
Note:
Always replace seal on threaded plug!
•
Install liberally oiled chain tensioner with flat sur-
face toward chain
•
Turn engine through at least one full revolution
– Check valve clearances
X
Torque specification:
Threaded plug.............................................. 35 Nm
# Cylinder head cover removal and
installation
– Swivel out powertrain cradle (
a
11.12)
•
Open hose clamp (arrow) with pliers,
BMW No. 17 5 500
.
•
Undo attachment bolts (1) on valve cover
•
Watch throttle (arrow)
When installing:
•
Before installing, clean cylinder head gasket and
groove for gasket in cylinder head cover
e
Attention:
Install with no oil on gasket or in recess within the
cylinder head cover!
X
Torque specification:
Cylinder head cover ..................................... 10 Nm
C1000150
1
17 5 500
C1000160