24.9
Installing driven variator
For the sake of clarity, these illustrations show the
vehicle with the powertrain cradle removed.
e
Attention:
Installed position of belt with legend on outside!
•
Lay belt in position between the two belt contact
faces
•
Grease needle roller
•
Spray variator shaft splines
•
Check position of spring
L
Note:
Press up and at the same time turn upper belt pulley
clockwise to push belt inward between the two pul-
leys .
•
Squeeze lengths of belt together and install to-
gether with driven variator
•
Push belt between plates of drive variator
•
Mount variator on variator shaft
•
Install clutch drum
•
Use retainer,
BMW No. 11 7 521,
to apply coun-
terpressure and install nut
Fluids and lubricants:
Needle bush.......................................... Shell HDX2
X
Torque specification:
Clutch drum ................................................. 60 Nm
C1110430
C1110440
11 7 521
C1110451
To Next Page
Loading...
