00.61
Adding distilled water
•
Remove threaded plug
L
Note:
Never use anything other than distilled water to top
up the battery's electrolyte!
•
Add distilled water up to the maximum level
•
Installation is the reverse of the removal proce-
dure
Clean/grease battery terminals if
necessary
(Inspection IV)
– Remove cover from battery compartment
•
Clean the battery terminals and grease them with
acid-proof battery grease
Fluids and lubricants:
Battery terminal ..........Acid-resistant battery grease
Checking Bowden cables
(Inspections III and IV)
•
Check Bowden cables for damage from rubbing
and abrasion
•
Check freedom of movement and adjust, if nec-
essary
a
................................................... See Group 32
Throttle cable:
•
Move the handlebars all the way from left to right
and ensure that throttle valve does not move
Checking easy-lift mechanism
(Inspections I, II, III and IV)
•
Check operation of mechanism and check free-
dom of movement
•
Check Bowden cables for damage from rubbing
and abrasion
•
Check free travel of Bowden cables and adjust
as required
Specification:
– The small lever must move up and down be-
tween the two limit stops
– Adjust Bowden cables without free travel, allow-
ing the stand springs to hold the stand in its end
position (
a
46.44)
C1610030
min
max
To Next Page
Loading...
