BMW C1 200 - Replacing Throttle Cable

32.13
32 72 305
Replacing throttle cable
– Remove handlebar trim
– Remove instrument trim
–Open the seat
a
....................................................See Group 46
– Remove combination switch on right
•
Pull rubber cap (2) down
•
Remove fastener (1) for throttle cable
•
Disengage throttle cable from holder and cam
disc
•
Remove throttle cable
When installing:
•
While installation is basically a reversal of the re-
moval process, careful attention should be di-
rected toward the following:
•
Check throttle cable play, adjusting if necessary
Adjustment data:
Move the handlebars all the way from left to right
and ensure that throttle valve does not move
X
Torque specification:
Combination switch mount............................. 4 Nm
Throttle cable mount ...................................... 8 Nm
C1130060
2
1