65.9
•
Remove rubber cap (1) from receiver
•
Disconnect plug (2)
When installing:
•
While installation is basically a reversal of the re-
moval process, careful attention should be di-
rected toward the following:
e
Attention:
When installing take pains to ensure that all wiring is
routed correctly! Position to avoid potential rubbing
and abrasion!
Motion sensor replacement
– Deactivate alarm system (
a
65.4)
–Remove seat
– Remove the backrest
a
....................................................See Group 52
– Remove rear left side panel
a
....................................................See Group 46
•
Disconnect plug (1)
•
Remove fastener (2)
L
Note:
A tape strip with adhesive backing on both
sides (arrow) serves as a supplementary attachment
for the motion sensor!
•
Motion sensor removal
C1650090
2
1
C1650080
1
2
To Next Page
