00.25
Use BMW MoDiTeC/DIS plus to
access stored error codes
•
Open seat by inserting ignition key in lock at the
left rear
•
Release backrest mount and remove backrest
•
Connect diagnosis unit to diagnosis plug
•
Access stored error codes
•
Carry out any repair operations indicated
•
Install backrest
Check tyre inflation pressures
•
Check/correct tyre inflation pressures
Tyre inflation pressures:
One-up.............................. Front 1.9 bar (27.56 psi)
.......................................... Rear 2.1 bar (30.46 psi)
Full load ............................ Front 2.1 bar (30.46 psi)
.......................................... Rear 2.4 bar (34.81 psi)
Add fuel
•
Open the seat
•
Pour in fuel
Operation check as final inspection
•
Check engine oil
•
Safety belt release mechanism
•
Clutch engagement speed
•
Steering
•
Front and rear brakes
•
Check lights and signalling equipment:
– Front and rear parking lamps
– Instrument illumination
– Headlamp, high beam, headlamp flasher
– Brake lamp (actuation of front and rear brakes)
– Left/right turn signals
–Horn
– Indicator and warning lights
– Instruments
•
Check any optional equipment to confirm that it
is operational, check ABS, carry out driving test.
When vehicle is ridden for at least 10 seconds at
over 30 km/h (19 miles/h) the ABS warning lamp
will come on if there any problems in the ABS
•
Conduct road test as required
•
Confirm delivery in service and technology man-
ual
•
Respond to problems by refering to "Checking
C1 for defects"
C1000010
C1000040
To Next Page
