BMW C1 200 - Replacing Oil Pump; Removing and Installing Oil Pump

11.20
Replacing oil pump
11 11 300 Removing and installing oil pump
– Remove reluctor (
a
12.8)
•
Turn over the engine until the attachment bolts
(arrows) come into view
•
Release bolts and remove pump
When installing:
•
The outer rotor bears a punch mark for identifica-
tion
L
Note:
Make sure that punch mark is toward inside of pump
housing!
•
Liberally coat oil-pump channels and preassem-
bled pump with oil before installing
•
Note position of gearwheel (arrow)
•
Coat threads of self-tapping screws with Loctite
prior to installation (Tapite screws)
•
Turn pump so that tooth-edge gap can be
checked
•
Check axial float of pump
Fluids and lubricants:
Tapite bolts ........................................... Loctite 243
X
Torque specification:
Oil pump ........................................................ 6 Nm
C1110280
C1110290