BMW C1 200 - Programming the Alarm System; Activating the Programming Mode

65.5
Programming the alarm system
It is possible to modify the standard factory settings
by programming in selected functions for buzzer,
panic alarm and tone type. Automatic activation of
the immobilizer and automatic activation of the
alarm function can be set to mode A, B or C accord-
ing to customer preference.
Mode A:
Buzzer.............................................................. OFF
Panic alarm ...................................................... OFF
Tone type .................................... VARIABLE PITCH
Automatic activation - immobilizer..................... ON
Automatic activation - alarm function ............... OFF
Mode B:
Buzzer............................................................... ON
Panic alarm ....................................................... ON
Tone type .................................... VARIABLE PITCH
Automatic activation - immobilizer.................... OFF
Automatic activation - alarm function ............... OFF
Mode C:
Buzzer............................................................... ON
Panic alarm ....................................................... ON
Tone type .................................... VARIABLE PITCH
Automatic activation - immobilizer..................... ON
Automatic activation - alarm function ................ ON
L
Note:
Program the system using button (A) and button (B)
on the remote control unit (1). Programming is pos-
sible only with the system deactivated.
Activating the programming mode
– Deactivate the alarm system (the turn signals
flash briefly, the indicator LED goes out)
–Open the seat
– Open rear storage compartment cover
– Remove battery cover
– Deactivate the alarm system again if necessary
•
Connect the negative lead of the programmer
plug (arrow, brown/white wire) with a wire to
earth (battery –)
within
12 seconds
•
Press button (A) on the remote control unit
– The buzzer sounds twice with an extended tone
– The turn signals flash twice
– Indicator LED is off
•
Switch on the ignition
within
12 seconds
– The buzzer emits three sequential tones of differ-
ent pitch
– The programming mode is active
•
Remove the wire between the programming plug
(brown/white wire) and earth (battery –)
C1650030