65.4
Deactivating the immobilizer
With the ignition on, deactivate the
immobilizer
by
pressing the button (A) on the remote control unit or
sticking the inductive key (2) on the indicator
LED (D) on the vehicle.
– The vehicle is ready to start
Supplementary (manual) activation of the alarm
function (with immobilizer already active)
•
With the vehicle immobilizer activated and the ig-
nition off, press button (A) on the remote control
unit (1) or place the inductive key (2) on the indi-
cator LED (D); this activates the alarm function in
addition to the immobilizer
– The turn signals flash twice
– After 15 seconds the indicator LED (D) starts to
flash
– Now the alarm mode is activated in addition to
the immobilizer
– After an additional 50 seconds the motion sensor
starts to operate
L
Note:
Now attempts to start the vehicle, disconnect a bat-
tery cable or move the vehicle will trigger an alarm
lasting 30 seconds; the siren sounds, the turn sig-
nals flash, the current supply to the starter relay is
interrupted and the emergency off function is acti-
vated.
Deactivating the immobilizer and alarm func-
tions
•
With the ignition
off, press
button (A) on the re-
mote control unit (1) on place inductive key (2) on
the indicator LED (D)
– Simultaneous deactivation of immobilizer and
alarm functions
– Turn signals flash briefly
– The system is now deactivated and the indicator
LED is off
L
Note:
After deactivation you have 15 seconds to switch on
the ignition; after this period the immobilizer auto-
matically resumes active operation.
The is the system's mode A (basic factory setting
with automatic activation of the vehicle immobilizer
and manual activation of the alarm function)
To Next Page
Loading...
