46.50
Powertrain cradle
Overview
Locknut for bearing pin, left M28x1.5 (1)
Bering pin, left (2)
Bearing bushing (3)
Coupling for swing arm bearing mount (4)
Bearing bush (5)
Bearing sleeve, right (6)
Hex screw, M12x1.5x55 (7)
Hex nut, M12 (8)
Bearing bush (9)
Spacer sleeve (10)
Tubular swing arm (11)
Bearing bushing (12)
Pin, joint (13)
e
Attention:
The protrusion on the right is less than on the left on
the swing arm coupling (4)!
Note swing arm bearing configuration when install-
ing coupling (4)!
46 71 020
Removing powertrain cradle
mounts
•
Raise C1 slightly with hoist (1),
BMW No. 00 1 570,
and ensure that C1 is stand-
ing securely
•
Use hoist (2) to support engine
C1460620
1 2 6543
11 9101213
7
8
C1460630
00 1 570
2
1
To Next Page
