EasyManua.ls Logo

BMW C1 200 - Maintenance Intervals; 1,000 Km;600 Miles Inspection; BMW Service; BMW Annual Service

BMW C1 200
458 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
00.31
00
Maintenance intervals
1,000 km/600 miles Inspection
BMW Break-in Inspection after the initial 1,000 km/
600 miles
BMW Service
At the end of the first 7,500 km/4,500 miles
and then at intervals of 15,000 km/9,000 miles,(at
22,500 km, 37,500 km…/13,500 miles,
22,500 miles… )
BMW Inspection
At the end of the first 15,000 km/9,000 miles
and then at intervals of additional 15,000 km/
9,000 miles,(at 30,000 km, 45,000 km…/18,000 miles,
27,000 miles…)
BMW Annual Service
Although many service operations are scheduled
according to milage, many procedures (such as
brake fluid changes) should be carried out at least
once a year, regardless of elapsed milage.
If these operations are not performed in the course
of a standard, milage-based Service or Inspection,
an extra visit for an Annual Service will be required.
The codes for service and maintenance intervals in
this repair manual are as follows:
– BMW Inspection at 1,000 km/600 miles ............
I
– BMW Maintenance Service every
7,500 km/4,500 miles .......................................
II
– BMW Inspection every 15,000 km/9,000 miles
III
– BMW Annual Service ......................................
IV
Operations specified for extended-milage vehi-
cles:
Replacement of complete drive variator (
a
00.58)
a
............................. Refer to Assembly Group 24
.......................................... for more information
Vehicles with ABS: replace handbrake fittings (rub-
ber diaphragm on brake master cylinder) (
a
00.64)
a
............................. Refer to Assembly Group 32
.......................................... for more information
Replace fuel filter (
a
00.63)
a
............................. Refer to Assembly Group 16
.......................................... for more information
Reading out BMW MoDiTeC/DIS
and error codes stored in ECU
(Inspections I, II, III and IV)
Open the seat
Remove the backrest
Connect
BMW
MoDiTeC/DIS plus diagnosis ca-
ble to diagnostic interface (arrow)
L
Note:
Follow the instructions in the diagnosis program.
C1000010

Table of Contents

Related product manuals