00.22
•
Remove weight from vehicle
•
Release long lever (1) from the detent mecha-
nism by
– first moving the lever (1) on the easy-lift mecha-
nism all the way forward and up, and then slowly
pushing it downward
– Keep a firm grip on the lever
– The front wheel is lowered to the ground
•
Hold C1 vertical
•
Push short lever (2) on easy-lift mechanism
downward
– The stand retracts
•
Ensure that the long lever (1)
is locked at the bot-
tom
•
Check that the stand is fully retracted
L
Note:
The easy-lift mechanism has overload protection. If
necessary, use your foot to retract the stand.
•
Push C1 off the pallet backwards
e
Attention:
Make sure the surface under the vehicle is level and
firm!
Do not park the C1 on slopes of more than 6°/12%,
as the stand may fail to provide secure support.
•
Place C1 on stand (
a
00.19)
e
Attention:
Do not cut adhesive tape - can damage shoulder
bar!
•
Remove protective wrap from shoulder bar
•
Dispose of the shipping materials through eco-
logically sound channels, refer to bikebox
C1000370
1
C1000410
1
2
C1000420
To Next Page
