63.6
Replacing headlight bezel
– Remove headlight
– Remove subframe
•
Remove locking device (2)
•
Push shaft (1) up to remove
•
Remove swivel frame
When installing:
Installation is the reverse of the removal procedure
X
Torque specification:
Subframe attachment..................................... 9 Nm
63 12 241/250
Replacing high-beam/low-
beam bulb
L
Note:
Never touch inside of reflector and glass on bulbs
with bare fingers!
•
Disconnect plug (1)
•
Remove rubber cap (2)
•
Turn retaining ring (3) counter-clockwise to re-
lease and remove
•
Remove H4 bulb (4)
When installing:
•
Installation is the reverse of the removal proce-
dure
C1630080
1
2
C1630040
1
2
3
4
To Next Page
