00.37
•
Remove hose from bracket on intake-air plenum
chamber (arrow)
•
Position vehicle jack
BMW No. 00 1 570
with at-
tachment
BMW No. 00 1 580
at separation point
•
Raise the vehicle slightly
•
Install fixture,
BMW No. 33 1 531,
between left
spring strut and powertrain cradle
•
Remove lower end of right spring strut from
brake caliper holder
e
Attention:
To avoid stretching hoses and lines, do not swivel
the powertrain cradle more than 20°!
•
Lift C1 no further than stop: powertrain cradle
swivels down
When installing:
•
Install the cylinder head cover before swiveling
the powertrain cradle back into place
e
Attention:
Ensure that gasket and cover are free of oil!
•
Installing cylinder head cover
e
Attention:
When lowering note positions of struts and intake-
air plenum chamber!
L
Note:
Ensure that the detent engages to secure the long
lever on the easy-lift mechanism. If necessary, move
the lever to the drive position first, and then move it
to the park position.
X
Tightening torque:
Cylinder head cover ..................................... 10 Nm
Strut, lower .................................................. 21 Nm
C1000130
C1000140
00 1 570
33 1 531
00 1 580
To Next Page
Loading...
