11.18
•
Support the weight of the vehicle on floor jack
positioned beneath frame
•
Secure assembly brace,
BMW No. 11 0 651,
to
powertrain cradle
•
Remove fastener securing suspension and re-
move axle
•
Detach the spring struts from the powertrain cra-
dle and tie up out of the way
•
Using extension,
BMW No. 11 0 652
, and stand,
BMW No. 00 1 490
, pull powertrain cradle to the
rear to remove
When installing:
•
While installation is the reversal of the removal
procedure, special attention should be devoted
to the following points:
1Adding coolant
2 Slacken vent plug in cylinder head until liquid
emerges, then retighten vent plug
3 Pour in remainder of coolant
4 Briefly let engine run, then correct coolant level in
expansion tank
d
Warning:
Never re-use the original 6-point lug nut on the rear
wheel
Fluids and lubricants:
Loctite 243
Shell Retinax EP2
X
Torque specification:
Powertrain cradle mount to separation
point............................................................. 73 Nm
Injector mount
(+Loctite 243) ................................................. 4 Nm
Drain plug .................................................... 10 Nm
Vent screw .................................................... 9 Nm
Throttle cable attachment .............................. 8 Nm
Auxiliary swing arm mount............................ 21 Nm
Auxiliary swing arm mount M10
(+ Loctite 243) .............................................. 60 Nm
6-point nut for input shaft........................... 130 Nm
Lower strut mount ........................................ 21 Nm
Silencer mount on auxiliary swing arm ......... 21 Nm
Attachment, exhaust pipe to cylinder head .. 21 Nm
11 0 651
C1110150
11 0 652
C1110071
00 1 490
To Next Page
