Brocade Communications Systems FastIron X Series User Manual

Hello 739 738 29556 29520
DbDesc 2 2 236 2536
LSReq 1 1 1444 88
LSUpdate 344 258 71464 23256
LSAck 30 291 6780 11396
OSPF messages dropped,no authentication: 0
ve 17 admin up, oper up, IPv6 enabled
IPv6 Address:
fe80::214:ff:fe77:96ff
5100::192:213:111:213/112
5100::192:213:111:0/112
Instance ID 0, Router ID 192.168.98.213
Area ID 0.0.0.200, Cost 1, Type BROADCAST
MTU: 10178
State BDR, Transmit Delay 1 sec, Priority 1, Link-LSA Tx not suppressed
Timer intervals :
Hello 10, Hello Jitter 10 Dead 40, Retransmit 5
Authentication Use: Enabled
KeyRolloverTime(sec): Configured: 300 Current: 0
KeyRolloverState: NotActive
Outbound: None
Inbound: None
DR:192.168.98.111 BDR:192.168.98.213 Number of I/F scoped LSAs is 2
DRElection: 1 times, DelayedLSAck: 7 times
Neighbor Count = 1, Adjacent Neighbor Count= 1
Neighbor:
192.168.98.111 (DR)
Statistics of interface ve 17 :
Type tx rx tx-byte rx-byte
You can display detailed OSPFv3 information about a
specic interface using the following command at any level of the CLI.
Syntax: show ipv6 ospf interface [ brief ] [ ethernet unit/slot/port ] [ loopback number ] [tunnel number ] [ ve number ]
The ethernet, loopback , tunnel, and ve parameter specify the interface for which to display information. If you specify an Ethernet
interface, also specify the port number associated with the interface. If you specify a loopback, tunnel, or VE interface, also specify the
number associated with the interface.
TABLE 75 show ipv6 ospf interface output descriptions
This eld Displays
Interface status The status of the interface. Possible status includes the following:
• Up.
• Down.
Type The type of OSPFv3 circuit running on the interface. Possible types
include the following:
• BROADCAST
• POINT TO POINT UNKNOWN
• POINT TO POINT
IPv6 Address The IPv6 address assigned to the interface.
Instance ID An identier for an instance of OSPFv3.
Router ID The IPv4 address of the device. By default, the router ID is the IPv4
address congured on the lowest numbered loopback interface. If the
device does not have a loopback interface, the default router ID is the
lowest numbered IPv4 address congured on the device.
Area ID The IPv4 address or numerical value of the area in which the interface
belongs.
Cost The overhead required to send a packet through the interface.
default Shows whether or not the default passive state is set.
Displaying OSPFv3 information
FastIron Ethernet Switch Layer 3 Routing
328 53-1003627-04

Brocade Communications Systems FastIron X Series Specifications

General

Brand	Brocade Communications Systems
Model	FastIron X Series
Category	Switch
Language	English