The table shows a description of the output for the show ip vrrp and show ip vrrp-extended commands.
TABLE 106 Output description for VRRP-E detailed information
Field Description
Total number of VRRP (or VRRP-Extended) routers dened The total number of VRIDs congured on this Layer 3 switch.
NOTE
The total applies only to the protocol the Layer 3 switch is
running. For example, if the Layer 3 switch is running VRRP-E,
the total applies only to VRRP-E routers.
Interface parameters
Interface The interface on which VRRP, VRRP v3, VRRP-E, or IPv6 VRRP-E is
congured. If VRRP, VRRP v3, VRRP-E, or IPv6 VRRP-E is congured
on multiple interfaces, information for each interface is listed separately.
auth-type The authentication type enabled on the interface.
VRID parameters
VRID The VRID congured on this interface. If multiple VRIDs are congured on
the interface, information for each VRID is listed separately.
state This Layer 3 switch VRRP, VRRP v3, VRRP-E, or IPv6 VRRP-E state for
the VRID. The state can be one of the following:
• initialize - The VRID is not enabled (activated). If the state
remains "initialize" after you activate the VRID, make sure that
the VRID is also congured on the other routers and that the
routers can communicate with each other.
NOTE
If the state is "initialize" and the mode is incomplete, make sure
you have specied the IP address for the VRID.
• backup - This Layer 3 switch is a Backup for the VRID.
• master - This Layer 3 switch is the Master for the VRID.
administrative-status The administrative status of the VRID. The administrative status can be
one of the following:
• disabled - The VRID is congured on the interface but VRRP or
VRRP-E has not been activated on the interface.
• enabled - VRRP, VRRP v3, VRRP-E, or IPv6 VRRP-E has
been activated on the interface.
mode Indicates whether the Layer 3 switch is the Owner or a Backup for the
VRID.
NOTE
If "incomplete" appears after the mode, conguration for this
VRID is incomplete. For example, you might not have
congured the virtual IP address that is being backed up by the
VRID.
NOTE
This eld applies only to VRRP or VRRP v3. All Layer 3
switches congured for VRRP-E are Backups.
priority The device preferability for becoming the Master for the VRID. During
negotiation, the router with the highest priority becomes the Master.
If two or more devices are tied with the highest priority, the Backup
interface with the highest IP address becomes the active router for the
VRID.
Displaying VRRP and VRRP-E information
FastIron Ethernet Switch Layer 3 Routing
546 53-1003627-04
To Next Page
Loading...
Need help?
General
