EasyManuals Logo

Brocade Communications Systems FastIron X Series User Manual

Brocade Communications Systems FastIron X Series
593 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #547 background imageLoading...
Page #547 background image
TABLE 106 Output description for VRRP-E detailed information (continued)
Field Description
current priority The current VRRP, VRRP v3, VRRP-E, or IPv6 VRRP-E priority of this
Layer 3 switch for the VRID. The current priority can dier from the
congured priority (refer to the priority eld) for the following reason:
The current priority can dier from the congured priority in the VRID if
the VRID is congured with track ports and the link on a tracked interface
has gone down.
hello-interval The congured value for the Hello interval. This is the amount of time, in
milliseconds, between Hello messages from the Master to the Backups
for a given VRID.
NOTE
In some VRRP command outputs, Hello interval timers are
displayed in seconds instead of milliseconds.
dead interval The congured value for the dead interval. This is the amount of time, in
milliseconds, that a Backup waits for a Hello message from the Master for
the VRID before determining that the Master is no longer active.
If the Master does not send a Hello message before the dead interval
expires, the Backups negotiate (compare priorities) to select a new Master
for the VRID.
NOTE
If the value is 0, then you have not congured this
parameter.
NOTE
This eld does not apply to VRRP
Owners.
NOTE
All timer elds (Hello interval, dead interval, current dead
interval, and so on) are displayed in milliseconds.
current dead interval The current value of the dead interval. This value is equal to the value
congured for the dead interval.
If the value for the dead interval is not congured, then the current dead
interval is equal to three times the Hello interval plus Skew time (where
Skew time is equal to 256 minus priority divided by 256).
NOTE
This eld does not apply to VRRP
Owners.
preempt mode Whether the backup preempt mode is enabled.
NOTE
This eld does not apply to VRRP
Owners.
virtual ip address The virtual IP addresses that this VRID is backing up. The address can be
an IPv4 or IPv6 address.
virtual mac address The virtual MAC addresses for the VRID. The MAC address can be an
IPv4 or IPv6 address.
advertise backup The IP addresses of Backups that have advertised themselves to this
Layer 3 switch by sending Hello messages.
Displaying VRRP and VRRP-E information
FastIron Ethernet Switch Layer 3 Routing
53-1003627-04 547

Table of Contents

Other manuals for Brocade Communications Systems FastIron X Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Brocade Communications Systems FastIron X Series and is the answer not in the manual?

Brocade Communications Systems FastIron X Series Specifications

General IconGeneral
BrandBrocade Communications Systems
ModelFastIron X Series
CategorySwitch
LanguageEnglish

Related product manuals