Brocade Communications Systems FastIron X Series User Manual

TABLE 106 Output description for VRRP-E detailed information (continued)
Field Description
NOTE
Hello messages from Backups are disabled by default. You
must enable the Hello messages on the Backup for the
Backup to advertise itself to the current Master.
backup router ip-addr expires in time The IP addresses of Backups that have advertised themselves to this
Master by sending Hello messages.
The time value indicates how long before the Backup expires. A Backup
expires if you disable the advertise backup option on the Backup or the
Backup becomes unavailable. Otherwise, the Backup next Hello message
arrives before the Backup expires. The Hello message resets the
expiration timer.
An expired Backup does not necessarily aect the Master. However, if you
have not disabled the advertise backup option on the Backup, then the
expiration may indicate a problem with the Backup.
NOTE
This eld applies only when Hello messages are enabled on
the Backups (using the advertise backup option).
next hello sent in time How long until the Backup sends its next Hello message.
NOTE
This eld applies only when this Layer 3 switch is the Master
and the Backup is congured to send Hello messages (the
advertise backup option is enabled).
master router ip-addr expires in time The IP address of the Master and the amount of time until the Master
dead interval expires. If the Backup does not receive a Hello message
from the Master by the time the interval expires, either the IP address
listed for the Master will change to the IP address of the new Master, or
this Layer 3 switch itself will become the Master.
NOTE
This eld applies only when this Layer 3 switch is a
Backup.
track port The interfaces that the VRID interface is tracking. If the link for a tracked
interface goes down, the VRRP, VRRP v3, VRRP-E, or IPv6 VRRP-E
priority of the VRID interface is changed, causing the devices to
renegotiate for Master.
NOTE
This eld is displayed only if track interfaces are congured for
this VRID.
Displaying detailed information for an individual VRID
You can display information about the settings congured for a specied VRRP Virtual Router ID (VRID). To display information about
VRID 1, enter the show ip vrrp vrid command.
device#show ip vrrp vrid 2
VRID 2
Interface ethernet v2
state master
administrative-status enabled
version v2
Displaying VRRP and VRRP-E information
FastIron Ethernet Switch Layer 3 Routing
548 53-1003627-04

Brocade Communications Systems FastIron X Series Specifications

General

Brand	Brocade Communications Systems
Model	FastIron X Series
Category	Switch
Language	English