Troubleshooting Guide
334
If you selected [Clean nowf], the shutter will make a noise, but no
picture is taken (p.224).
If you repeatedly switch the power to <1>/<2> at a short interval,
the <f> icon may not be displayed (p.37).
What is displayed on the screen differs depending on the printer. This
instruction manual lists all the printing effects available (p.273).
If [52: Wi-Fi] is set to [Enable], direct printing via an interface cable is
not possible. Set [Wi-Fi] to [Disable], then connect the camera to the
printer with an interface cable.
Sensor Cleaning Problems
The shutter makes a noise during sensor cleaning.
Automatic sensor cleaning does not work.
Printing-Related Problems
There are fewer printing effects than listed in the instruction
manual.
Direct printing does not work.
To Next Page
