Canon EOS M2 - Take the Picture

47
Image Stabilizer
Use the Image Stabilizer switch on the lens.
Set the STABILIZER switch to <1>.
1
Press the shutter button halfway.
 The Image Stabilizer will operate.
2
Take the picture.
 When the picture looks steady on the
LCD monitor, press the shutter button
completely to take the picture.
With a Non-EF-M Lens
Using the Image Stabilizer when Shooting
 The Image Stabilizer cannot correct “subject blur”, when the subject moves at
the time of exposure.
 For bulb exposures, set the IS to <2>. If <1> is set, Image Stabilizer
misoperation may occur.
 The Image Stabilizer may not be effective for excessive shaking such as on a
rocking boat.
 The Image Stabilizer works in all focus modes.
 When the IS is set to <2>, H will appear on the screen.
 When using a tripod, you can still shoot with the IS set to <1> with no
problem. However, to save battery power, setting the IS to <2> is
recommended.
 The Image Stabilizer is effective even when the camera is mounted on a
monopod.