Important
•
Do not touch the Linear Scale (a) or Carriage Shaft (b).
This may stain your hands and damage the printer.
Note
• Here, the Belt Stopper is the one that was removed and stored after initial installation.
4
Close the Top Cover.
5
If any options are attached to the printer, remove them from the printer and pack them.
6
Tape down printer covers to secure them, in the reverse order of tape removal during installation.
7
Repack the Roll Holder, Holder Stopper, and printer in shipping materials, and then package them in a shipping
box.
iPF6400S
Preparing to Transfer the Printer
User's Guide
Maintenance and Consumables Other Maintenance
927
To Next Page
Loading...
Need help?
General