M-Series Operator’s Manual 4/9/15
10-88
F10 - Save Keep the updated tool offset library values.
F2 - Tools Now you need to make sure that each tool uses the correct
diameter and height offset values. Inspect the values for T001
and T002. T1 should use H001 and D001, while T002 should use
H002 and D002. If any of these values are incorrect, use the
arrow keys to select the incorrect values. Enter the new values in
their places and press ENTER to accept them. You may also
select spindle and coolant settings for your tools here, or enter a
short description of the tool.
F10 - Save Keep the updated Tool Library values.
ESC/CANCEL Leave Tool Setup. Return to the CNC software Setup Screen.
ESC/CANCEL Leave CNC software Setup. Return to the CNC software Main
Screen.
CYCLE START The CYCLE START/START button is located on your jog
panel. This key will cause the mill to begin cutting your part.
Tutorial Complete!
To Next Page
Loading...
