M-Series Operator’s Manual 4/9/2015 10-19
Deep Hole Drilling (F1 in the Canned Cycle Menu: option #3)
If you press F1 - Drill from the Canned Cycle Menu you will gain access to three types of drilling operations:
Drilling, Chip Breaking, and Deep Hole drilling. The current drilling operation in use is reflected in the field Cycle
Type, and pressing F3 - Toggle or SPACE toggles between all three. In this section we will examine the third option:
Deep Hole drilling.
The numbers in the fields on the screen correspond to the following example, shown here graphically:
Where:
Cycle Type: Selects one of three drilling operations: Drilling, Chip Breaking, or Deep Hole drilling. Press F3-Toggle
or SPACE to toggle between the three choices.
To Next Page
Loading...
