READ THIS MANUAL BEFORE USING THIS PRODUCT.
FAILURE TO FOLLOW THE INSTRUCTIONS AND SAFETY
PRECAUTIONS IN THIS MANUAL CAN RESULT IN
SERIOUS INJURY OR DEATH.
All operators and service personnel must read this manual before operating
CENTROID CNC control equipment and all connected machine tools.
Keep this manual in a safe location for future reference.
Throughout this manual and on associated products where applicable, in accordance with
ANSI Z535, the following symbols and words are used as defined below:
DANGER
“DANGER” with or without a red background =
Hazard WILL cause death or serious injury if
ignored.
WARNING
“WARNING” with or without an orange
background = Hazard COULD cause death or
serious injury if ignored.
CAUTION
“CAUTION” with or without a yellow
background = Hazard MAY cause minor to
moderate injury if ignored.
NOTICE
“NOTICE” with or without a blue background =
Indicates an action to prevent damage to the
product or other materials used with product.
Information provided by CENTROID relating to wiring, installation, and operation of CNC
components is intended as only a guide, and in all cases a qualified technician and all
applicable local codes and laws must be consulted. CENTROID makes no claims about the
completeness or accuracy of the information provided, as it may apply to an infinite number of
field conditions.
As CNC control products from CENTROID can be installed on a wide variety of machine tools
NOT sold or supported by CENTROID, you MUST consult and follow all safety
instructions provided by your machine tool manufacturer regarding the safe operation
of your machine and unique application.
To Next Page
Loading...
