M-Series Operator’s Manual 4/9/15 15-2
Error Message Cause & Effect Action
307 Operator abort: job
canceled
ESC or CYCLE CANCEL pressed. Job is
cancelled.
308 Waiting for input #NN
M100 or M101 executing. Program will continue
once specified input opens or closes.
309 Waiting for CYCLE
START button
M0, M1, M100/75, or Block Mode is executed. Press Cycle Start
310 Waiting for output
#NN
M100 or M101 executing. Program will continue
once specified output opens or closes.
311 Waiting for memory
#NN
M100 or M101 executing. Program will continue
once specified memory bit changes to the correct
state.
312 Waiting for PLC
operation (Mnn)
PLC program not clearing PLC operation in
progress
313 Waiting for dwell time
G4 executing. Program waits for specified dwell
time then continues.
314 Waiting for system
#NN
M100 or M101 executing. Program will continue
once specified PLC system variable changes to the
correct state.
315 Searching... Run/search in progress
317 Waiting for automatic
tool change
mfunc6.mac executing
318 Operator Abort
probing cancelled
ESC or CYCLE CANCEL pressed while doing a
probing move
319 Probing cycle
cancelled
probing cycle was cancelled
320 Probe stuck
probe is stuck, or probe hit an object when it wasn't
expecting contact.
322 Stall: probing
cancelled
probing was cancelled because of a stall
323 Stall: job cancelled job was cancelled because of a stall
324 Limit: probing
cancelled
probing was cancelled because of a limit error
325 Limit: job cancelled job was cancelled because of a limit error
326 Fault: probing
cancelled
probing was cancelled because of a fault
327 Fault: job cancelled job was cancelled because of a fault
328 Cutter comp error: job
cancelled
job was cancelled because of a cutter comp error
329 Invalid parameter: job
cancelled
job was cancelled because of an invalid parameter
330 Canned cycle error:
job cancelled
job was cancelled because of a canned cycle error
332 Search Failed Run/Search was unable to find the requested G-
code line
334 Locating position to
resume job...
Run/Search is locating the j
the program
335 Emergency Stop
Released
Emergency Stop Button has been released
336 Digitize cancelled ESC or CYCLE CANCEL pressed during
digitizing
337 Digitize complete A digitizing routine ran to completion
338 Job Cancelled ESC or CYCLE CANCEL pressed during job run
To Next Page
Loading...
