11-6
Catalyst 3750 Metro Switch Software Configuration Guide
78-15870-01
Chapter 11 Configuring VTP
Configuring VTP
VTP pruning is not designed to function in VTP transparent mode. If one or more switches in the
network are in VTP transparent mode, you should do one of these:
• Turn off VTP pruning in the entire network.
• Turn off VTP pruning by making all VLANs on the trunk of the switch upstream to the VTP
transparent switch pruning ineligible.
To configure VTP pruning on an interface, use the switchport trunk pruning vlan interface
configuration command (see the “Changing the Pruning-Eligible List” section on page 10-23). VTP
pruning operates when an interface is trunking. You can set VLAN pruning-eligibility, whether or not
VTP pruning is enabled for the VTP domain, whether or not any given VLAN exists, and whether or not
the interface is currently trunking.
Configuring VTP
This section includes guidelines and procedures for configuring VTP. These sections are included:
• Default VTP Configuration, page 11-6
• VTP Configuration Options, page 11-7
• VTP Configuration Guidelines, page 11-8
• Configuring a VTP Server, page 11-9
• Configuring a VTP Client, page 11-11
• Disabling VTP (VTP Transparent Mode), page 11-12
• Enabling VTP Version 2, page 11-13
• Enabling VTP Pruning, page 11-14
• Adding a VTP Client Switch to a VTP Domain, page 11-15
Default VTP Configuration
Table 11-2 shows the default VTP configuration.
Table 11-2 Default VTP Configuration
Feature Default Setting
VTP domain name Null.
VTP mode Server.
VTP version Version 1 (version 2 is disabled).
VTP password None.
VTP pruning Disabled.
To Next Page
Loading...
