Cisco Catalyst 3750 - Configuring UDLD; Default UDLD Configuration; UDLD Configuration Guidelines

20-4
Catalyst 3750 Metro Switch Software Configuration Guide
78-15870-01
Chapter 20 Configuring UDLD
Configuring UDLD
Configuring UDLD
This section describes how to configure UDLD on your switch. It contains this configuration
information:
• Default UDLD Configuration, page 20-4
• UDLD Configuration Guidelines, page 20-4
• Enabling UDLD Globally, page 20-5
• Enabling UDLD on an Interface, page 20-5
• Resetting an Interface Disabled by UDLD, page 20-6
Default UDLD Configuration
Table 20-1 shows the default UDLD configuration.
UDLD Configuration Guidelines
These are the UDLD configuration guidelines:
• UDLD is not supported on ATM ports.
• A UDLD-capable interface also cannot detect a unidirectional link if it is connected to a
UDLD-incapable interface of another switch.
• When configuring the mode (normal or aggressive), make sure that the same mode is configured on
both sides of the link.
Table 20-1 Default UDLD Configuration
Feature Default Setting
UDLD global enable state Globally disabled
UDLD per-port enable state for fiber-optic media Disabled on all Ethernet fiber-optic ports
UDLD per-port enable state for twisted-pair (copper) media Disabled on all Ethernet 10/100 and 1000BASE-TX ports
UDLD aggressive mode Disabled