Cisco Catalyst 3750 - Unsupported Interface Configuration Commands; IP Multicast Routing; Unsupported Privileged EXEC Commands

C-5
Catalyst 3750 Metro Switch Software Configuration Guide
78-15870-01
Appendix C Unsupported Commands in Cisco IOS Release12.1(14)AX
IP Multicast Routing
Unsupported Interface Configuration Commands
bandwidth {bandwidth-kbps | percent percent}
random-detect [dscp-based | precedence-based]
random-detect dscp dscp min-threshold max-threshold mark-prob-denominator
random-detect exponential-weighting-constant weight
random-detect precedence ip-precedence min-threshold max-threshold mark-prob-denominator
switchport broadcast level
switchport multicast level
switchport unicast level
Note The switchport broadcast, switchport multicast, and switchport unicast commands have been
replaced by the storm-control {broadcast | multicast | unicast} level level [.level] interface
configuration command.
IP Multicast Routing
Unsupported Privileged EXEC Commands
clear ip rtp header-compression [type number]
The debug ip packet command displays packets received by the switch CPU. It does not display packets
that are hardware-switched.
The debug ip mcache command affects packets received by the switch CPU. It does not display packets
that are hardware-switched.
The debug ip mpacket [detail] [access-list-number [group-name-or-address] command affects only
packets received by the switch CPU. Because most multicast packets are hardware-switched, use this
command only when you know that the route will forward the packet to the CPU.
debug ip pim atm
show frame-relay ip rtp header-compression [interface type number]
The show ip mcache command displays entries in the cache for those packets that are sent to the switch
CPU. Because most multicast packets are switched in hardware without CPU involvement, you can use
this command, but multicast packet information is not displayed.
The show ip mpacket commands are supported but are only useful for packets received at the switch
CPU. If the route is hardward-switched, the command has no effect because the CPU does not receive
the packet and cannot display it.
show ip pim vc [group-address | name] [type number]
show ip rtp header-compression [type number] [detail]