EasyManuals Logo

Cisco Catalyst 3750 Software Configuration Guide

Cisco Catalyst 3750
926 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #603 background imageLoading...
Page #603 background image
CHAPTER
28-1
Catalyst 3750 MetroSwitch Software Configuration Guide
78-15870-01
28
Configuring IP Unicast Routing
This chapter describes how to configure IP unicast routing on the Catalyst 3750 Metro switch.
Note For more detailed IP unicast configuration information, refer to the Cisco IOS IP and IP Routing
Configuration Guide for Release 12.1. For complete syntax and usage information for the commands
used in this chapter, refer to the Cisco IOS IP and IP Routing Command Reference for Release 12.1.
This chapter consists of these sections:
Understanding IP Routing, page 28-2
Steps for Configuring Routing, page 28-3
Configuring IP Addressing, page 28-4
Enabling IP Unicast Routing, page 28-17
Configuring RIP, page 28-18
Configuring IGRP, page 28-23
Configuring OSPF, page 28-28
Configuring EIGRP, page 28-37
Configuring BGP, page 28-43
Configuring ISO CLNS Routing, page 28-63
Configuring Multi-VRF CE, page 28-76
Configuring Protocol-Independent Features, page 28-86
Monitoring and Maintaining the IP Network, page 28-100
Note When configuring routing parameters on the switch and to allocate system resources to maximize the
number of unicast routes allowed, you can use the sdm prefer routing global configuration command
to set the Switch Database Management (SDM) feature to the routing template. For more information on
the SDM templates, see Chapter 6, “Configuring SDM Templates,” or refer to the sdm prefer command
in the command reference for this release.

Table of Contents

Other manuals for Cisco Catalyst 3750

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 3750 and is the answer not in the manual?

Cisco Catalyst 3750 Specifications

General IconGeneral
Device TypeSwitch
Switching Capacity32 Gbps
Forwarding Rate38.7 Mpps
Stacking Bandwidth32 Gbps
RAM128 MB
Jumbo Frame SupportYes
Switch TypeManaged
ModelCatalyst 3750 Series
Uplink InterfacesSFP
Form FactorRack-mountable
MAC Address Table Size12, 000 entries
Routing ProtocolRIP, OSPF, EIGRP
Remote Management ProtocolSNMP, Telnet, HTTP
FeaturesLayer 3 switching, Layer 2 switching, auto-negotiation, BOOTP support, ARP support, VLAN support, auto-uplink (auto MDI/MDI-X), IGMP snooping, traffic shaping, MAC address filtering, Quality of Service (QoS), Jumbo Frames support, MLD snooping, Dynamic ARP Inspection (DAI), Cisco EnergyWise technology
Power over Ethernet (PoE)PoE
Operating Temperature-5 - 45 °C
Operating Humidity10% to 85% non-condensing

Related product manuals