Cisco Catalyst 3750 Software Configuration Guide

33-8
Catalyst 3750 Metro Switch Software Configuration Guide
78-15870-01
Chapter 33 Configuring Fallback Bridging
Configuring Fallback Bridging
Adjusting BPDU Intervals
You can adjust BPDU intervals as described in these sections:
• Adjusting the Interval between Hello BPDUs, page 33-8 (optional)
• Changing the Forward-Delay Interval, page 33-9 (optional)
• Changing the Maximum-Idle Interval, page 33-9 (optional)
Note Each switch in a spanning tree adopts the interval between hello BPDUs, the forward delay interval, and
the maximum idle interval parameters of the root switch, regardless of what its individual configuration
might be.
Adjusting the Interval between Hello BPDUs
Beginning in privileged EXEC mode, follow these step to adjust the interval between hello BPDUs. This
procedure is optional.
To return to the default setting, use the no bridge bridge-group hello-time global configuration
command.
This example shows how to change the hello interval to 5 seconds in bridge group 10:
Switch(config)# bridge 10 hello-time 5
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
bridge bridge-group hello-time seconds Specify the interval between hello BPDUs.
• For bridge-group, specify the bridge group number. The range is 1
to 255.
• For seconds, enter a number from 1 to 10. The default is 2.
Step 3
end Return to privileged EXEC mode.
Step 4
show running-config Verify your entry.
Step 5
copy running-config startup-config (Optional) Save your entry in the configuration file.

Cisco Catalyst 3750 Specifications

General

Device Type	Switch
Switching Capacity	32 Gbps
Forwarding Rate	38.7 Mpps
Stacking Bandwidth	32 Gbps
RAM	128 MB
Jumbo Frame Support	Yes
Switch Type	Managed
Model	Catalyst 3750 Series
Uplink Interfaces	SFP
Form Factor	Rack-mountable
MAC Address Table Size	12, 000 entries
Routing Protocol	RIP, OSPF, EIGRP
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Layer 3 switching, Layer 2 switching, auto-negotiation, BOOTP support, ARP support, VLAN support, auto-uplink (auto MDI/MDI-X), IGMP snooping, traffic shaping, MAC address filtering, Quality of Service (QoS), Jumbo Frames support, MLD snooping, Dynamic ARP Inspection (DAI), Cisco EnergyWise technology
Power over Ethernet (PoE)	PoE
Operating Temperature	-5 - 45 °C
Operating Humidity	10% to 85% non-condensing