Cisco ME 3400 - Page 1094

Index
IN-8
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
OL-9639-07
configuration files (continued)
uploading
preparing B-10, B-13, B-16
reasons for B-8
using FTP B-14
using RCP B-18
using TFTP B-11
configuration guidelines
aggregate policers 33-44
CBWFQ 33-54
CFM 41-6
class-based shaping 33-56
EtherChannel 34-10
Ethernet OAM 41-16
HSRP 38-5
individual policers 33-39
input policy maps 33-38
link-state tracking 34-24
marking in policy maps 33-46
multi-VRF CE 35-84
OAM manager 41-26
output policy maps 33-53
per-port, per-VLAN QoS 33-48
port security 22-11
QoS, general 33-30
QoS class maps 33-34
REP 17-7
rollback and replacement B-20
SSM 42-15
SSM mapp 42-17
strict priority queuing 33-58
unconditional priority policing 33-60
UNI VLANs 11-12
VLANs 11-8
WTD 33-63
configuration replacement B-19
configuration rollback B-19
configuration settings, saving 3-14
configure terminal command 9-8
configuring marking in input policy maps 33-46
configuring port-based authentication violation
modes
8-14
configuring small-frame arrival rate 22-5
congestion avoidance, QoS 33-2, 33-26
congestion management, QoS 33-2, 33-20
connections, secure remote 7-37
Connectivity Fault Management
See CFM
connectivity problems 44-10, 44-13, 44-14
console port, connecting to 2-9
control packets
and control-plane security 32-2
dropping and rate-limiting 32-2
control-plane security
configuring 32-6
control packets 32-2
monitoring 32-7
policers 32-3
policing 32-2
purpose of 32-1
control protocol, IP SLAs 39-4
convergence
REP 17-4
corrupted software, recovery steps with Xmodem 44-2
CoS
classification 33-8
values 33-5
counters, clearing interface 9-27
CPU overload, protection from 32-1
CPU policers 32-5
CPU protection 32-3
CPU threshold notification 29-21
CPU threshold table 29-1, 29-20
CPU utilization statistics 29-21
crashinfo file 44-21
crosscheck, CFM 41-4, 41-8