Index
IN-24
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
OL-9639-07
Layer 3 interfaces
assigning IP addresses to 35-5
assigning IPv4 and IPv6 addresses to 36-12
assigning IPv6 addresses to 36-10
changing from Layer 2 mode 35-5, 35-87, 35-88
types of 35-3
LDAP 4-2
Leaking IGMP Reports 18-4
lightweight directory access protocol
See LDAP
line configuration mode 2-2
Link Aggregation Control Protocol
See EtherChannel
Link Failure, detecting unidirectional 15-8
link integrity, verifying with REP 17-3
Link Layer Discovery Protocol
See CDP
link local unicast addresses 36-3
link monitoring, Ethernet OAM 41-15, 41-18
link redundancy
See Flex Links
links, unidirectional 25-1
link state advertisements (LSAs) 35-29
link-state tracking
configuration guidelines 34-24
configuring 34-24
described 34-22
LLDP
configuring 24-3
characteristics 24-4
default configuration 24-3
disabling and enabling
globally 24-5
on an interface 24-5
monitoring and maintaining 24-8
overview 24-1
supported TLVs 24-2
transmission timer and holdtime, setting 24-4
LLDP-MED
configuring 24-3
configuring TLVs 24-6
monitoring and maintaining 24-8
overview 24-1, 24-2
supported TLVs 24-2
LLDP Media Endpoint Discovery
See LLDP-MED
load balancing 38-4
local SPAN 26-2
location TLV 24-3, 24-6
logging messages, ACL 31-8
login authentication
with RADIUS 7-23
with TACACS+ 7-14
login banners 5-17
log messages
See system message logging
loop guard
described 16-5
enabling 16-10
support for 1-5
M
MAC addresses
aging time 5-22
and VLAN association 5-21
building the address table 5-21
default configuration 5-22
disabling learning on a VLAN 5-28
discovering 5-29
displaying 5-28
displaying in the IP source binding table 19-22
dynamic
learning 5-21
removing 5-23
in ACLs 31-26
IP address association 35-7
To Next Page
Loading...
