Cisco ME 3400 - Page 56

1-12
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
OL-9639-07
Chapter 1 Overview
Default Settings After Initial Switch Configuration
• Port type Gigabit Ethernet: NNI, Fast Ethernet
ports: UNI
Chapter 9, “Configuring Interfaces”
• Operating mode Layer 2 (switchport)
• Port enable state Enabled for NNIs; disabled for UNIs and
ENIs
• Interface speed and duplex mode Autonegotiate
• Auto-MDIX Enabled
• Flow control Off
Command Macros None configured Chapter 10, “Configuring Command
Macros”
VLANs
• Default VLAN VLAN 1 Chapter 11, “Configuring VLANs”
• VLAN interface mode Access
• VLAN type UNI isolated
• Private VLANs None configured Chapter 12, “Configuring Private VLANs”
Dynamic ARP inspection Disabled on all VLANs Chapter 20, “Configuring Dynamic ARP
Inspection”
Tunneling
• 802.1Q tunneling (requires metro
IP access or metro access image)
Disabled Chapter 13, “Configuring IEEE 802.1Q
Tunneling and Layer 2 Protocol
Tunneling”
• Layer 2 protocol tunneling
(requires metro IP access or metro
access image)
Disabled
Spanning Tree Protocol
• STP Rapid PVST+ enabled on NNIs in
VLAN 1
Chapter 14, “Configuring STP”
• MSTP Disabled (not supported on UNIs, can be
configured on ENIs)
Chapter 15, “Configuring MSTP”
• Optional spanning-tree features Disabled (not supported on UNIs, can be
configured on ENIs)
Chapter 16, “Configuring Optional
Spanning-Tree Features”
Resilient Ethernet Protocol (requires
metro IP access or metro access
image)
Not configured Chapter 17, “Configuring Resilient
Ethernet Protocol”
Flex Links (requires metro IP access
or metro access image)
Not configured Chapter 18, “Configuring Flex Links and
the MAC Address-Table Move Update
Feature”
DHCP snooping
Disabled Chapter 19, “Configuring DHCP Features
and IP Source Guard”
IP source guard Disabled Chapter 19, “Configuring DHCP Features
and IP Source Guard”
Table 1-1 Default Settings After Initial Switch Configuration (continued)
Feature Default Setting More information in...