Cisco ME 3400 - Page 57

1-13
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
OL-9639-07
Chapter 1 Overview
Default Settings After Initial Switch Configuration
IGMP snooping
• IGMP snooping Enabled Chapter 21, “Configuring IGMP Snooping
and MVR”
• IGMP filters None applied
• IGMP querier Disabled
• MVR Disabled
IGMP throttling Deny Chapter 21, “Configuring IGMP Snooping
and MVR”
Port-based Traffic Control
• Broadcast, multicast, and unicast
storm control
Disabled Chapter 22, “Configuring Port-Based
Traffic Control”
• Protected ports None defined
• Unicast and multicast traffic
flooding
Not blocked
• Secure ports None configured
CDP Enabled on NNIs, disabled on ENIs, not
supported on UNIs
Chapter 23, “Configuring CDP”
LLDP Disabled (not supported on UNIs) Chapter 24, “Configuring LLDP and
LLDP-MED”
UDLD Disabled Chapter 25, “Configuring UDLD”
SPAN and RSPAN Disabled Chapter 26, “Configuring SPAN and
RSPAN”
RMON Disabled Chapter 27, “Configuring RMON”
Syslog messages Enabled; displayed on the console Chapter 28, “Configuring System Message
Logging”
SNMP Enabled; Version 1 Chapter 29, “Configuring SNMP”
ACLs None configured Chapter 31, “Configuring Network
Security with ACLs”
QoS Not configured Chapter 33, “Configuring QoS”
EtherChannels None configured Chapter 34, “Configuring EtherChannels
and Link-State Tracking”
IP unicast routing
• IP routing and routing protocols
(requires metro IP access or metro
access image)
Disabled Chapter 35, “Configuring IP Unicast
Routing”
• Multi-VRF-CE (requires metro IP
access or metro access image)
Disabled
HSRP groups (requires metro IP
access image)
None configured Chapter 38, “Configuring HSRP”
Cisco IOS IP SLAs Not configured Chapter 39, “Configuring Cisco IOS IP
SLAs Operations”
Table 1-1 Default Settings After Initial Switch Configuration (continued)
Feature Default Setting More information in...