29-13
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
OL-9639-07
Chapter 29 Configuring SNMP
Configuring SNMP
config Generates a trap for SNMP configuration changes.
copy-config Generates a trap for SNMP copy configuration changes.
cpu threshold Generates a trap for CPU threshold violations.
entity Generates a trap for SNMP entity changes.
envmon Generates environmental monitor traps. You can enable any or all of these environmental
traps: fan, shutdown, status, supply, temperature.
ethernet Generates an SNMP Ethernet trap.
flash Generates SNMP FLASH notifications.
hsrp Generates a trap for Hot Standby Router Protocol (HSRP) changes.
ipmulticast Generates a trap for IP multicast routing changes.
mac-notification Generates a trap for MAC address notifications.
msdp Generates a trap for Multicast Source Discovery Protocol (MSDP) changes.
ospf Generates a trap for Open Shortest Path First (OSPF) changes. You can enable any or all of
these traps: Cisco specific, errors, link-state advertisement, rate limit, retransmit, and state
changes.
pim Generates a trap for Protocol-Independent Multicast (PIM) changes. You can enable any or
all of these traps: invalid PIM messages, neighbor changes, and rendezvous point
(RP)-mapping changes.
port-security Generates SNMP port security traps. You can also set a maximum trap rate per second. The
range is from 0 to 1000; the default is 0, which means that there is no rate limit.
Note When you configure a trap by using the notification type port-security, configure the
port security trap first, and then configure the port security trap rate:
• snmp-server enable traps port-security
• snmp-server enable traps port-security trap-rate rate
rtr Generates a trap for the SNMP Response Time Reporter (RTR).
snmp Generates a trap for SNMP-type notifications for authentication, cold start, warm start, link
up or link down.
storm-control Generates a trap for SNMP storm-control. You can also set a maximum trap rate per minute.
The range is from 0 to 1000; the default is 0 (no limit is imposed; a trap is sent at every
occurrence).
stpx Generates SNMP STP Extended MIB traps.
syslog Generates SNMP syslog traps.
tty Generates a trap for TCP connections. This trap is enabled by default.
vlan-membership Generates a trap for SNMP VLAN membership changes.
vlancreate Generates SNMP VLAN created traps.
vlandelete Generates SNMP VLAN deleted traps.
Table 29-5 Switch Notification Types (continued)
Notification Type Keyword Description
To Next Page
Loading...
