32-7
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
OL-9639-07
Chapter 32 Configuring Control-Plane Security
Monitoring Control-Plane Security
Monitoring Control-Plane Security
You can monitor control-plane security settings and statistics on the switch or on an interface, and you
can clear these statistics at any time by using the privileged EXEC commands in
Table 32-2. For more
information about the commands, see the command reference for this release.
Ta b l e 32-2 Commands for Monitoring Control-Plane Security
Command Purpose
clear policer cpu uni-eni counters
{classification | drop}
Clear all control-plane statistics per feature (classification) or all statistics
maintained by the control-plane policer (drop).
debug platform policer cpu uni-eni Enable debugging of the control-plane policer. This command displays
information messages when any changes are made to CPU protection.
show platform policer cpu {classification |
interface interface-id}
Display control-plane policer information.
• classification—show classification statistics.
• interface interface-id—show policer indexes for the specified
interface.
show policer cpu uni-eni {drop [interface
interface-id] | rate}
Display CPU policer information for the switch.
• drop [interface interface-id] —show the number of dropped frames for
all interfaces or the specified interface.
• rate—show the configured threshold rate for CPU policers.
If CPU protection is disabled, this message appears in the output:
Switch# show policer cpu uni drop
CPU Protection feature is not enabled
To Next Page
Loading...
