35-101
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
OL-9639-07
Chapter 35 Configuring IP Unicast Routing
Configuring Protocol-Independent Features
Step 9
match interface type number [...type number] Match the specified next hop route out one of the
specified interfaces.
Step 10
match ip route-source {access-list-number |
access-list-name} [...access-list-number |
...access-list-name]
Match the address specified by the specified advertised
access lists.
Step 11
match route-type {local | internal | external [type-1 |
type-2]}
Match the specified route-type:
• local—Locally generated BGP routes.
• internal—OSPF intra-area and interarea routes or
EIGRP internal routes.
• external—OSPF external routes (Type 1 or Type 2)
or EIGRP external routes.
Step 12
set dampening halflife reuse suppress
max-suppress-time
Set BGP route dampening factors.
Step 13
set local-preference value Assign a value to a local BGP path.
Step 14
set origin {igp | egp as | incomplete} Set the BGP origin code.
Step 15
set as-path {tag | prepend as-path-string} Modify the BGP autonomous system path.
Step 16
set level {level-1 | level-2 | level-1-2 | stub-area |
backbone}
Set the level for routes that are advertised into the
specified area of the routing domain. The stub-area and
backbone are OSPF NSSA and backbone areas.
Step 17
set metric metric value Set the metric value to give the redistributed routes (for
EIGRP only). The metric value is an integer
from
-294967295 to 294967295.
Step 18
set metric bandwidth delay reliability loading mtu Set the metric value to give the redistributed routes (for
EIGRP only):
• bandwidth—Metric value or IGRP bandwidth of the
route in kilobits per second in the range 0 to
4294967295
• delay—Route delay in tens of microseconds in the
range 0 to 4294967295.
• reliability—Likelihood of successful packet
transmission expressed as a number between 0 and
255, where 255 means 100 percent reliability and 0
means no reliability.
• loading— Effective bandwidth of the route expressed
as a number from 0 to 255 (255 is 100 percent
loading).
• mtu—Minimum maximum transmission unit (MTU)
size of the route in bytes in the range 0 to
4294967295.
Step 19
set metric-type {type-1 | type-2} Set the OSPF external metric type for redistributed routes.
Step 20
set metric-type internal Set the multi-exit discriminator (MED) value on prefixes
advertised to external BGP neighbor to match the IGP
metric of the next hop.
Command Purpose
To Next Page
Loading...
Need help?
General
