Cisco ME 3400 - Page 860

36-24
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
OL-9639-07
Chapter 36 Configuring IPv6 Unicast Routing
Displaying IPv6
3FFE:C000:0:7::777/128
attached to Vlan7
3FFE:C000:0:7:20B:46FF:FE2F:D97F/128
receive
3FFE:C000:111:1::/64
attached to GigabitEthernet0/11
3FFE:C000:111:1:20B:46FF:FE2F:D945/128
receive
3FFE:C000:168:1::/64
attached to GigabitEthernet0/43
3FFE:C000:168:1:20B:46FF:FE2F:D94B/128
receive
3FFE:C000:16A:1::/64
attached to Loopback10
3FFE:C000:16A:1:20B:46FF:FE2F:D900/128
receive
<output truncated>
This is an example of the output from the show ipv6 protocols privileged EXEC command:
Switch# show ipv6 protocols
IPv6 Routing Protocol is “connected”
IPv6 Routing Protocol is “static”
IPv6 Routing Protocol is “rip fer”
Interfaces:
Vlan6
GigabitEthernet0/4
GigabitEthernet0/11
GigabitEthernet0/12
Redistribution:
None
This is an example of the output from the show ipv6 rip privileged EXEC command:
Switch# show ipv6 rip
RIP process "fer", port 521, multicast-group FF02::9, pid 190
Administrative distance is 120. Maximum paths is 16
Updates every 30 seconds, expire after 180
Holddown lasts 0 seconds, garbage collect after 120
Split horizon is on; poison reverse is off
Default routes are not generated
Periodic updates 9040, trigger updates 60
Interfaces:
Vlan6
GigabitEthernet0/4
GigabitEthernet0/11
GigabitEthernet0/12
Redistribution:
None
This is an example of the output from the show ipv6 neighbor privileged EXEC command:
Switch# show ipv6 neighbors
IPv6 Address Age Link-layer Addr State Interface
3FFE:C000:0:7::777 - 0007.0007.0007 REACH Vl7
3FFE:C101:113:1::33 - 0000.0000.0033 REACH Gi0/13
This is an example of the output from the show ipv6 static privileged EXEC command:
Switch# show ipv6 static
IPv6 Static routes
Code: * - installed in RIB
* ::/0 via nexthop 3FFE:C000:0:7::777, distance 1