41-11
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
OL-9639-07
Chapter 41 Configuring Ethernet OAM, CFM, and E-LMI
Configuring Ethernet CFM
To remove an IP SLAs operation, enter the no ip sla operation-number global configuration command.
Step 10
threshold milliseconds (Optional) Specify the upper threshold value in
milliseconds (ms0 for calculating network monitoring
statistics. The range is 0 to 2147483647; the default is
5000.
Step 11
timeout milliseconds (Optional) Specify the amount of time in ms that the IP
SLAs operation waits for a response from its request
packet. The range is 0 to 604800000; the default value is
5000.
Step 12
exit Return to global configuration mode.
Step 13
ip sla schedule operation-number [ageout seconds]
[life {forever | seconds}] [recurring] [start-time
{hh:mm {:ss} [month day | day month] | pending |
now | after hh:mm:ss}]
Schedule the time parameters for the IP SLAs operation.
• operation-number—Enter the IP SLAs operation
number.
• (Optional) ageout seconds—Enter the number of
seconds to keep the operation in memory when it is not
actively collecting information. The range is 0 to
2073600 seconds. The default is 0 seconds.
• (Optional) life—Set the operation to run indefinitely
(forever) or for a specific number of seconds. The
range is from 0 to 2147483647. The default is 3600
seconds (1 hour)
• (Optional) recurring—Set the probe to be
automatically scheduled every day.
• (Optional) start-time—Enter the time for the
operation to begin collecting information:
–
To start at a specific time, enter the hour, minute,
second (in 24-hour notation), and day of the
month.
–
Enter pending to select no information collection
until a start time is selected.
–
Enter now to start the operation immediately.
–
Enter after hh:mm:ss to show that the operation
should start after the entered time has elapsed.
Step 14
end Return to privileged EXEC mode.
Step 15
show ip sla configuration [operation-number] Show the configured IP SLAs operation.
Step 16
copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Purpose
To Next Page
Loading...
Need help?
General
