Cisco RV110W Administration Guide

Configuring VPN
Configuring Advanced VPN Parameters
Cisco RV110W Administration Guide 104
5
In the IKE SA Parameters section, the Security Association (SA) parameters
define the strength and mode for negotiating the SA. You can configure the
following settings:
• Encryption Algorithm—Choose the algorithm used to negotiate the SA:
- DES
- 3DES
- AES-128
- AES-192
- AES-256
• Authentication Algorithm—Specify the authentication algorithm for the
VPN header:
- MD5
- SHA-1
- SHA2-256
Ensure that the authentication algorithm is configured identically on both
sides of the VPN tunnel (for example, the Cisco RV110W and the router
to which it is connecting).
• Pre-Shared Key—Enter the key in the space provided. Note that the
double-quote character (“) is not supported in the pre-shared key.
• Diffie-Hellman (DH) Group—Specify the DH Group algorithm, which is
used when exchanging keys. The DH Group sets the strength of the
algorithm in bits. Ensure that the DH Group is configured identically on both
sides of the IKE policy.
• SA Lifetime—Enter the interval, in seconds, after which the Security
Association becomes invalid.
• Dead Peer Detection—Check the Enable box to enable this feature, or
uncheck the box to disable it. Dead Peer Detection (DPD) is used to detect
whether the peer is alive or not. If peer is detected as dead, the router
deletes the IPsec and IKE Security Association. If you enable this feature,
also enter these settings:
- DPD Delay—Enter the interval, in seconds, between consecutive DPD
R-U-THERE messages. DPD R-U-THERE messages are sent only when
the IPsec traffic is idle.

Cisco RV110W Specifications

General

Ethernet LAN	Yes
Cabling technology	10/100Base-T(X)
Networking standards	IEEE 802.11b, IEEE 802.11e, IEEE 802.11g, IEEE 802.11n, IEEE 802.1p, IEEE 802.3, IEEE 802.3u
VPN tunnels quantity	10
Ethernet LAN data rates	10, 100 Mbit/s
Ethernet LAN interface type	Fast Ethernet
Wi-Fi standards	802.11b, 802.11g, Wi-Fi 4 (802.11n)
Channels quantity	13 channels
Top Wi-Fi standard	Wi-Fi 4 (802.11n)
Ethernet LAN (RJ-45) ports	4
Input voltage	12 V
Rack mounting	No
Number of users	32 user(s)
Weight (imperial)	0.61 lbs
Dimensions (WxDxH)	150 x 150 x 30 mm
Operating temperature (T-T)	32 - 104 °F
Compliance industry standards	IEEE 802.3, IEEE 802.3u
Supported data transfer rates	10/100Mbps
Dimensions (W x D x H) (imperial)	5.91 x 5.91 x 1.18 \
WLAN data transfer rates supported	11, 54 Mbit/s
Supported network protocols	PPPoE, DHCP, PPTP, L2TP, IGMP, RSTP
Antennas quantity	2
Antenna gain level (max)	1.8 dBi
Firewall security	VPN
Security algorithms	WEP, WPA, WPA2, WPS
MAC address filtering	-
Product color	Black
Certification	FCC, CE, IC, cUL, Wi-Fi
Storage temperature (T-T)	-20 - 70 °C
Storage relative humidity (H-H)	5 - 90 %
Operating relative humidity (H-H)	10 - 85 %

Weight and Dimensions

Width	150 mm
Height	30 mm
Weight	300 g