Cisco RV110W - Configuring the E-Mailing of Logs

Administering Your Cisco RV110W
Configuring Logging
Cisco RV110W Administration Guide 126
7
Configuring the E-Mailing of Logs
You can configure the Cisco RV110W to send logs by email. We recommend that
you set up a separate email account for sending and receiving logs.
You must first set up the severity of logs you want to capture; see Configuring
Logging Settings.
To configure the e-mailing of logs:
STEP 1 Choose Administration > Logging > E-mail Settings.
STEP 2 To enable the e-mailing of log events, check Enable.
STEP 3 The minimum email log severity of logs you want to capture appears. To change
this, click Configure Severity.
STEP 4 Configure the following settings:
E-mail Server Address Enter the address of the SMTP server. This is the
mail server associated with the email account
you’ve setup (for example,
mail.companyname.com ).
E-mail Server Port Enter the SMTP server port. If your email provider
requires a special port for email, enter it here.
Otherwise, use the default (25).
Return E-mail Address Enter the return email address that the
Cisco RV110W will send messages to if logs from
the router to the send-to email address are
undeliverable.
Send to E-mail
Address (1)
Enter an email address to which to send logs (for
example,
logging@companyname.com ).
Send to E-mail
Address (2) (Optional)
Enter an additional email address to which to send
logs.
Send to E-mail
Address (3) (Optional)
Enter an additional email address to which to send
logs.
E-mail Encryption (SSL) To enable email encryption, check Enable.