Configuring Networking
Configuring Routing
Cisco RV110W Administration Guide 42
2
To configure static routing:
STEP 1 Choose Networking > Routing.
STEP 2 From the Route Entries drop-down menu, choose a route entry.
To delete the route entry, click Delete This Entry.
STEP 3 Configure the following settings for the selected route entry:
STEP 4 Click Save.
Configuring Inter-VLAN Routing
Check the Inter-VLAN Routing box to enable routing between the separate VLANs
on the Cisco RV110W.
Enter Route Name Enter the name of the route.
Destination LAN IP Enter the IP address of the destination LAN.
Subnet Mask Enter the subnet mask of the destination network.
Gateway Enter the IP address of the gateway used for this
route.
Interface Select the interface to which packets for this route
are sent:
• LAN & Wireless—Click this button to direct packets
to the LAN and wireless network.
• Internet (WAN)—Click this button to direct packets
to the Internet (WAN).