Configuring Networking
Configuring IPv6
Cisco RV110W Administration Guide 56
2
Configuring Router Advertisement
The Router Advertisement Daemon (RADVD) on the Cisco RV110W listens for
router solicitations in the IPv6 LAN and responds with router advertisements as
required. This is stateless IPv6 auto configuration, and the Cisco RV110W
distributes IPv6 prefixes to all nodes on the network.
To configure the RADVD:
STEP 1 Choose Networking > IPv6 > Router Advertisement.
STEP 2 Enter this information:
RADVD Status Check Enable to enable RADVD.
Advertise Mode Select one of the following modes:
Unsolicited Multicast—Select this mode to send
Router Advertisements (RAs) to all interfaces
belonging to the multicast group.
Unicast only—Select this mode to restrict
advertisements to well-known IPv6 addresses only
(RAs are sent to the interface belonging to the
known address only).
Advertise Interval If you choose Unsolicited Multicast as the
advertise mode, enter the advertise interval
(4–1800). The default is 30. The advertise interval is
a random value between the Minimum Router
Advertisement Interval (MinRtrAdvInterval) and
Maximum Router Advertisement Interval
(MaxRtrAdvInterval).
MinRtrAdvInterval = 0.33 * MaxRtrAdvInterval
RA Flags Check Managed to use the administered/stateful
protocol for address auto configuration.
Check Other to use the administered/stateful
protocol of other, non-address information auto
configuration.